This is an automated archive.

The original was posted on /r/ubiquiti by /u/EnforceMarketing on 2023-08-15 21:13:19+00:00.

I’ve got a detached office I built about 300ft from my home which I have a hard line run to, with a Switch Lite 8 PoE & Access Point U6 Lite inside.

Short story long, something happened to the hard line, and I need to get internet back up and running in there ASAP as my wife works from home full time.

I have no desire to dig a new 300ft trench to run direct bury cable to the office, so instead I’m going to go with a B2B bridge.

My question(s) is/are this:

1. On the office end of the B2B bridge, I just need to take the output of the B2B and plug it into a POE port of the Switch Lite 8 PoE which will then power the B2B bridge, as well as bring WAN into the switch?
2. Then I can plug the Access Point U6 Lite into the Switch Lite 8 PoE, which will give me WiFi inside the office?

Do I have all that correct?

Thanks in advance!