This is an automated archive.

The original was posted on /r/ubiquiti by /u/zm1868179 on 2023-08-15 20:59:57+00:00.

So try to figure out if this might currently be possible what I’m trying to do.

We have two buildings.

The primary building is where our internet connection and everything else lives currently there is a Cisco catalyst 9000 series switch they’re acting as the core switch and A Palo Alto acting as the firewall.

For our second building we’re going full UniFi and going to connect the buildings via 2 air fiber ptp.

We have purchased 2 unifi dream machine SE one for each building( we will eventually be putting unifi in the main building).

An an enterprise 48 poe unifi switch.

The main building is primarily 10.40.x.x

While the 2nd building will be 10.41.x.x

I know how to disable nat on the dream machine so everything would just pass through it.

Can I use the routing rules to route the 10.41.x.x traffic to my Palo while another route rule to route guest traffic 192.168.x.x from the 2nd building which would be routed to the other dream machine which will have a public IP on its when interface to act as the guest gateway.